Intelia Cappuccino Customer And Programming Menu - Saeco Intelia Service Manual

INTELIA
3.1.

Intelia Cappuccino customer and programming menu

espresso dispensing
button
Long espresso
dispensing button
special beverages
selection button
Machine ready signals (GREEN)
Machine at correct temperature
- for coffee bean dispensing
- for hot water dispensing
Machine at correct temperature
- for ground bean dispensing
(pre-ground)
Hot water or hot milk selection
Hot water dispensing
Dispensing hot milk
Machine dispensing milk during
the preparation of cappuccino
Machine dispensing coffee during
the preparation of cappuccino
Notice signals (ORANGE)
Machine in pre-heating phase
for coffee, hot water and steam
dispensing
The appliance is rinsing, wait
until end of operation
The machine signals that the
"INTENZA+"
replaced
If this screen appears after you switch the machine on, it means that you must run
a descaling cycle.
Press "
Press "
Saeco International Group
fi lter must
" to access the descaling menu and consult the relative paragraph.
" to continue using the machine.
Rev. 02 / September 2012
MEMO
MEMO
MEMO
be
03 USER INSTRUCTIONS
ON/OFF button
Aroma button / Pre-ground
button
button MENU
cappuccino dispensing button
Machine dispensing
1 espresso
Machine dispensing
1 coffee
Machine dispensing
2 espresso
Machine dispensing
2 coffees
The machine is being programmed
with the coffee cup fi ll level
The machine is being programmed
with the amount of milk to be
dispensed to prepare cappuccino
The machine is being programmed
with the amount of coffee to be
dispensed to prepare cappuccino
Brewing unit resetting
appliance reset
Fill the coffee bean container and
start the dispensing cycle
Proceed to load the circuit
during
Page 01 / 10