Saeco Intelia Service Manual page 20

INTELIA
Alarm signals (RED)
Close the service door.
No beans inside the coffee
container.
After fi lling the container, the
cycle can be restarted.
The Brewing Unit must be
inserted in the machine.
Switch the machine off, wait for 30 seconds. Repeat 2 or 3 times.
If the machine does NOT start, remove brewing unit, clean it, grease it and re-insert.
If the problem persist contact the service center.
MENU (commands and programming)
The programming menu can be accessed only when the machine is switched on
Press the menu button to access the programming menu
+
ESC
Coffee temperature (only Class)
MAX
MED
This function allows the coffee dispensing temperature to be adjusted.
MIN
-
Timer (stand-by) (only Class)
This function lets you adjust the time for switching to Stand By after the last
dispensing.
+
ESC
Contrast (only Class)
Display
This function lets you adjust the display contrast for better viewing of the
contrast
messages.
-
Water hardness (Focus and Class)
This function lets you adjust the water hardness so that machine maintenance is
managed better:
1 = very soft water 2= soft water 3 = hard water 4 = very hard water
"INTENZA+" water fi lter (Focus and Class)
This function lets you manage the "INTENZA+" water fi lter.
For details see the paragraph concerning the fi lter management.
Descaling Cycle (Focus and Class)
This function lets you execute a descaling cycle.
+
ESC
Factory settings (only Class)
DEFAULT
YES
This function allows the factory values to be reset.
SETTINGS
NO
-
Saeco International Group Rev. 02 / September 2012
03 USER INSTRUCTIONS
Insert the dreg drawer.
Empty the dreg drawer and the
drip tray.
Fill water tank.
Page / 10
07