Table of Contents
Advertisement
TROUBLESHOOTING
Push buttons
or controls
are sticky
or hard to
operate
Image is
over/under-
exposed, or a
corner of the
image is dark
• Remove the camera and rinse the closed housing
in freshwater. Vigorously press each push button
in and out several times to release any trapped
saltwater or debris.
• Press a sticky push button all the way in and
place a small amount of lube on the small end
of the push button shaft at it's base. Release
and operate the push button several times to
distribute the lube, Diagram H, Page 22.
• If a larger gland style control is sticky, grab the
control knob, pull it out, and then push back in. If
still sticky, see the Control Maintenance section,
Diagram I, Page 23.
• Return housing to Ikelite for routine maintenance.
• Check to see the strobe or camera flash is firing
when taking a picture
• Adjust your camera settings.
• Move closer to or farther away from the subject.
Optimal distance is approximately 3 feet (1 m) or
less.
• Position your strobe(s) closer to or farther away
from your subject.
• Reposition your strobe to better light the subject.
• Adjust Flash Exposure Compensation
.
25
Advertisement
Table of Contents
