Step 5 - Attach The Hotshoe; Step 6 - Closing The Housing - Ikelite 6970.07 User Manual

STEP 5 - Attach the Hotshoe

Slide Hotshoe into the top camera
mount until it stops. Hotshoe must
be all the way forward in the camera
mount to assure a good electrical
connection with a strobe.
Make sure hotshoe cord does
not interfere with controls or the
housing back when closing the
housing.

STEP 6 - Closing the Housing

1. Place housing face down in your lap or on a flat surface. Check to
see that there is an o-ring on the housing back, and that it is clean
and in its proper location.
2. Guide the back onto the housing front.
Make sure the hotshoe wire is out of the
way. Once the back is properly installed,
the o-ring should touch the housing all
the way around. There should be an
even gap on each side of the housing
between the housing and the back.
3. Lift the lid snaps so they are extended and place each lid snap
into the corresponding hook on the housing back.
4. To close the housing, push down on the opposing lid snaps
simultaneously until they snap into place. Be sure they are down
far enough to engage the lock - Page 10. The o-ring seal should
now appear as a solid black line from the back of the housing.
Hotshoe
Even Gap on
all 4 sides
Housing Back
Lid Snap
Lid Hook
O-ring
13