Table of Contents
Advertisement
Entering the Water
As soon as you enter the water, take a moment and check to see that
the housing is properly sealed. We recommend you first water test
the housing with no camera inside to assure a safe and watertight
environment.
Next, check to see if there are any bubbles on the face of the lens
port. If there are, take your finger and remove them. If there are
bubbles on the lens port they can produce soft focus spots in your
photos or video.
Removing the Camera from the Housing
1. Thoroughly dry housing.
2. Remove the housing back, see Opening the Housing, Step 3,
Page 10.
3. Remove the Hotshoe from the camera mount.
4. Use the index and middle finger of a hand to pull the Thumb
Screw away from the Mounting Plate, Diagram A, page 11.
If you are finished using the housing, remove the Mounting
Tray from the camera bottom and slide it back into the Housing
Mounting Plate, then replace
the Housing Back. For
storage and travel, remove
the back o-ring and place in
a small plastic bag. Place the
bag inside the housing and
re-attach the housing back.
Note: The Mounting Tray needs
to be removed when changing a
camera battery or memory card.
Optional Dome Port 5516.15
Diagram E
15
Advertisement
Table of Contents
