See Figs.5 And - JVC KD-SHX701 Service Manual

QQ
3.1.3 Removing the top chassis assembly 3 7 63 1515 0
(See Figs.3 to 6)
• Prior to performing the following procedures, remove the heat
sink.
Reference:
Remove the front panel assembly as required.
(1) From the bottom side of the main body, remove the two
screws C attaching the top chassis assembly to the bottom
chassis assembly. (See Fig.3)
(2) From the both and rear sides of the main body, remove the
four screws D attaching the top chassis assembly to the
bottom chassis assembly. (See Figs.4 to 6)
(3) Lift the top chassis assembly in the direction of the arrow,
and disconnect the connector
control board from the connector
board. (See Figs.5 and 6)
(4) Take out the top chassis assembly from the bottom chassis
assembly.
TE
L 13942296513
www
.
1-8 (No.MA047)
http://www.xiaoyu163.com
CN501 on the mechanism
CN702 on the main
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Bottom chassis assembly
C
Top chassis assembly
Q Q
3 6 7 1 3 1 5
Bottom chassis assembly
Mechanism control board
Top chassis assembly
Main board
Bottom chassis assembly
Top chassis assembly
co
Bottom chassis assembly
.
9 4 2 8
C
Top chassis assembly
Fig.3
0 5 8 2 9 9 4 2 8
D
Fig.4
CN501
D
CN702
Fig.5
D
m
Rear bracket
Fig.6
9 9
9 9
D