No.ma047)1 - JVC KD-SHX701 Service Manual

QQ
3.2.6 Removing the front unit 3 7 63 1515 0
(See 10 to 12)
• Prior to performing the following procedures, remove the top
cover and mechanism section.
(1) From the bottom side of the mechanism section, discon-
nect the flexible wire from connector
end board. (See Fig.10)
(2) From the top of the mechanism section, remove the screw
D attaching the front unit. (See Fig.11)
(3) Move the front unit toward the front to release joint i. (See
Fig.11)
(4) Release two joints j and k on the right side of the chassis
base. (See Fig.12)
(5) Take out the front unit upward, and remove the two screws
E attaching the switch wire. (See Fig.12)
Reference:
You can remove the switch wire only without removing the
front unit.
Caution:
When reassembling, attach the flexible wire extending from
the switch wire using a double-stick tape. (See Fig.12)
TE
L 13942296513
www
.
1-16 (No.MA047)
http://www.xiaoyu163.com
CN503 on the front-
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Q Q
3 6 7 1 3 1 5
Double-stick tape
Joint j
Joint k
co
Chassis base
.
9 4 2 8
Front-end
board
Flexible
wire
CN503
Fig.10
D
Front unit
0 5 8 2 9 9 4 2 8
Joint i
Fig.11
E
Switch wire
D
Front unit
m
Joint i
Fig.12
9 9
9 9