Table of Contents
Advertisement
USER INTERFACE
4.5.3 Modify Settings | Global Settings | Barcode Configuration
Use Barcode Configuration to configure how the system defines a no read barcode, and
configure and filter NOREAD messages.
To edit the Barcode Configuration:
1. In the tree menu under Modify Settings, navigate to Global Settings | Barcode
Configuration. The Barcode Configuration window opens.
2. Enter the appropriate information in the form as described below:
Field Name
Action/Definition
Code
Select Single Label, Standard Multi Label, Logical Combination, or Code
Combination
Collection from the drop-down list. The Code Combination parameter selects the
decoding mode for the scanner.
Single Label: In this mode only one barcode can be read in each reading
phase; however it can be determined automatically from up to 10 enabled
codes. The scanner stops decoding as soon as a code is read.
If the code is not read during the reading phase, the No Read message is
produced.
Standard Multi Label: In Multi Label mode the barcodes selected (up to 10),
will all be read in the same reading phase. If the reading phase terminates
before all the codes are read, a Global No Read message will be produced,
unless it is disabled, in which case a Local No Read will be produced.
NOTE: In case of Multi Label, the codes will be distinguished
EITHER by their symbology, OR by their contents. If two (or
more) codes share the same symbology and content, the
scanner will perceive them as a unique code.
Logical Combination: In Logical Combination mode the codes of the groups
defined by the Logical Combination Rule are read in the same reading phase.
Code Collection: In Code Collection mode expected codes are collected
within a single reading phase in the order in which they are read. The No Read
message is produced only if none of the codes are read. Up to 50 codes can
be collected.
4
73
Advertisement
Table of Contents
