Mechanical Installation; Preparing For Mechanical Installation - Datalogic DS8110 Reference Manual

2

2 MECHANICAL INSTALLATION

WARNING: Electrical Installation by Qualified Service Technicians Only!
Procedures may involve exposure to high-voltage. A trained and authorized
technician must perform these procedures. Do not attempt to perform any
electrical installation procedures unless you are a trained technician.
IMPORTANT: DS8110 barcode scanners contain electronics that may be
affected by electrostatic discharge (ESD).
damage to the unit, please follow the safety precautions and warnings found
in the References section at the beginning of this manual. Failure to follow
these precautions may void your warranty.

2.1 PREPARING FOR MECHANICAL INSTALLATION

IMPORTANT: Application-specific drawings and documents provided by
Datalogic supersede any contradictory content in this manual.
Before mounting any components, please do the following:

Read all instructions before beginning your installation.

Define and confirm the accuracy of your application's requirements and structure
position, especially the height of the conveyor from the floor.

Review all installation-specific drawings provided with your equipment.

Review and plan the mechanical installation of all devices used in your application. Be
sure to allow adequate clearance for maintenance.

Review and plan the power requirements for your application.

Check the contents of the shipping cartons against the packing list.

Record all product serial numbers.
NOTE: : Refer to the Chapter 3 Electrical Installation and Reference
Documentation for details on connecting your barcode scanners to other
devices in the system.
WARNING: When installing several scanners, take care to position them so
that no laser beam enters the reading window of other scanners. This
condition could occur more frequently for side mounted applications. If these
precautions are not followed, read rate could be negatively affected. To
resolve this problem, it is sufficient to slightly change the inclination and
position of one of the two scanners involved if possible.
12
DS8110 REFERENCE MANUAL
To prevent personal injury or