Table of Contents
Advertisement
2
2
CONFIGURATION USING BARCODE SYMBOLS
This section describes the programming method of using configuration barcode
symbols to program your reader. By using the LYNX™ reader to read/decode these
special configuration symbols, you can configure, and obtain information from its
system software.
When you are reading configuration barcode symbols, carefully aim the LYNX™ 2D
reader to avoid reading adjacent symbols.
The configuration barcode symbols in this chapter are divided into logical
sections according to the type of configuration required, (RS232 configuration,
Code selection, etc.). If arguments are required with a command, you can read
additional barcode labels (typically digits) from Appendix C.
To configure your reader:
1.
Open the folded page in Appendix C the Hex/Numeric table and keep it open
during the device configuration.
2.
Read the Enter Configuration code ONCE, available on the folded page in
Appendix C or in par. 2.2.1.
3.
Modify the desired parameters in one or more sections by reading the parameter
code and selecting the value from the Hex/Numeric table or by following the
given procedures.
4.
Read the Exit and Save Configuration code ONCE, available on the folded
page in Appendix C or in par. 2.2.1.
Example for step 3:
To set the maximum length of characters in a Code 39 barcode symbol that the
reader will decode to 32:
•
first read the Maximum Length symbol for Code 39 on page 50
•
then read the symbol for the digit "3" and lastly the symbol for the digit "2" in
Appendix C.
Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
14
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France
LYNX™
Advertisement
Table of Contents
