Testing Sound Via The Udirect 3 - Unitron uDirect 3 User Manual

The power indicator is lit as long as you press
a uDirect 3 button. Green confirms a good
uDirect 3 battery state, red indicates that you
need to charge the uDirect 3 battery.
Two minutes after unplugging the neckloop both
indicator lights will switch off and the uDirect 3
disconnects Bluetooth to save power.

Testing sound via the uDirect 3

1. Wear the uDirect 3 correctly.
2. Press and hold the access ( )
button while switching on the device.
Release the access button. The audio
indicator light with turn pink.
The hearing aids will switch to the streaming
mode and you will hear the uDirect 3 sound
demo.
Use the volume (
volume.
The sound demo will stop after three minutes
or when the access button is pressed.
Adjusting the volume during the sound demo
12
) buttons to adjust the
will also set the volume level of the spoken
uDirect 3 messages.
If you cannot hear the sound demo:
Make sure your hearing aids are inserted
•
correctly.
Make sure the uDirect 3 neckloop is
•
properly plugged in on both ends and worn
around your neck.
Make sure the uDirect 3 is charged and
•
switched on.
Make sure you are not on a phone call
•
connected through the uDirect 3.
13