Wearing The Udirect 2 Correctly; Testing Sound Via The Udirect 2 - Unitron uDirect 2 Manual

Wearing the uDirect 2 correctly

Before any phone, music or TV streaming can
take place, the uDirect 2 must be switched ON
and worn correctly as shown below:
1. Put the neckloop around
your neck (easily done by
unplugging one neckloop
plug).
2. Make sure both plugs
are well connected in the
neckloop sockets.
3. Switch the uDirect 2 ON.
For streaming, the neckloop must always be
plugged in. When unplugged, the uDirect 2
will go into sleep mode after two minutes. The
power and audio indicators will stop blinking
and all active Bluetooth connections are
terminated to save power. Plug the neckloop in
again to activate the streaming.
10

Testing sound via the uDirect 2

1. Wear the uDirect 2 correctly and switch it ON.
2. Press and hold the connect
( ) and access ( ) buttons
simultaneously for 2 seconds until
the audio indicator turns violet.
The hearing aids will switch to the
streaming mode and you will hear the uDirect 2
sound demo for 30 seconds after the last volume
adjustment.
Use the volume (
volume.
The sound demo will stop 30 seconds after the last
volume adjustment or by pressing any other key.
If you cannot hear the sound demo:
Make sure your hearing aids are inserted
correctly.
Make sure the uDirect 2 neckloop is properly
plugged in on both ends and worn around
your neck.
) buttons to adjust the
11