Setup Procedure - Epson TM-C3400 Technical Reference Manual

Setup Procedure

The setup procedure from the printer installation to ready-to-print status is described below.
1
Install the printer.
2
Connect the power supply unit.
3
Load the roll paper included in the package in the printer.
4
For Ethernet interface model, connect the printer to the network.
68)
5
Load the ink cartridge.
Turn on the printer before loading the ink cartridge.
It takes about 8 minutes for ink charging. When ink charging finishes, the POWER LED
stops flashing and stays on.
6
For the Ethernet interface model, make the network settings such as IP
address to the printer with EpsonNet Config.
7
For the USB interface model, connect the printer to the client computer.
(page 67)
Turn off the printer before connecting it to the client computer.
8
Install the printer driver (the install package) on the client computer, and
make the settings for it.
9
For the USB interface model, install the Printer Setting to the client com-
puter.
10
For the Ethernet interface model, install Printer Setting on a computer
that can access the printer (administrator computer or client computer).
11
Use Printer Setting on a client computer or administrator computer to
configure the printer.
(page 63)
(page
(page 65)
Chapter 5 Maintenance of the TM-C3400
64)
(page 83)
(page
5
217