Setup Procedure - Epson TM-C3400BK Technical Reference Manual

Setup Procedure

The setup procedure from the printer installation to ready-to-print status is described below.
1
Install the printer.
2
Connect the power supply unit.
3
Load the roll paper included in the package in the printer.
4
For Ethernet model, connect the printer to the network.
5
Load the ink cartridge.
Turn on the printer before loading the ink cartridge.
It takes about 8 minutes for ink charging. When ink charging finishes, the POWER LED stops
flashing and stays on.
6
For the Ethernet model, make the network settings such as IP address to the
printer with EpsonNet Config.
7
For the USB model, connect the printer to the client computer.
Turn off the printer before connecting it to the client computer.
8
Install the printer driver (the install package) on the client computer, and
make the settings for it.
9
For the USB model, install the Printer Setting to the client computer.
10
For the Ethernet model, install Printer Setting on a computer that can
access the printer (administrator computer or client computer).
11
Use Printer Setting on a client computer or administrator computer to con-
figure the printer.
12
Set the DIP switches of the printer.
Turn off the printer before setting the DIP switches.
13
Load the paper.
Set the paper according to the DIP switch setting.
14
Perform a test print.
218
(page 61)
(page
(page 63)
(page
(page 76)
62)
(page
74)
(page 81)
66)
(page 65)