F-31
CASE COVER REMOVAL AND REPLACEMENT PROCEDURE (continued)
FRONT SHROUD REMOVAL
PROCEDURE
1. Using the 5/16" nut driver, remove the
screws from the front control panel assem-
bly.
Do NOT remove the phillips head
screws. Lower the panel. See Figure F.5.
FRONT CONTROL
PANEL LOWERED
ARROWS INDICATE
SCREW LOCATIONS
2. Using the 5/16" nut driver, remove the four
screws from the left and right sides of the
shroud assembly. See Figure F.6.
FIGURE F.6 – SHROUD ASSEMBLY SCREW REMOVAL - SIDES
TROUBLESHOOTING & REPAIR
FIGURE F.5 – FRONT CONTROL PANEL REMOVAL
COMMANDER 400
SHROUD ASSEMBLY
REMOVE 2 SCREWS,
EACH SIDE
F-31