Lincoln Electric COMMANDER 400 SVM133-B Service Manual page 162

F-108
ENGINE, STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
12. Label and remove the four leads #224, #240,
#225 and #262 from the shutdown solenoid.
See Figure F.52. Cut any necessary cable
ties.
TROUBLESHOOTING & REPAIR
FIGURE F.52 – SHUTDOWN SOLENOID LEAD REMOVAL
PULL-IN COIL
(LARGER TERMINALS
EACH SIDE
#225 AND #262)
SHUTDOWN
SOLENOID
FIGURE F.53 – IDLER SOLENOID LEAD REMOVAL
SHUTDOWN
SOLENOID
COMMANDER 400
IDLER
SOLENOID
13. Label and remove leads #226, #237, #227
and #254 from the idler solenoid. See Figure
F.53 Cut any necessary cable ties.
PULL-IN COIL
(LARGER TERMINALS
TOP AND BOTTOM
#227 AND #254)
IDLER
SOLENOID
F-108
HOLD-IN COIL
(SMALLER TERMINALS
EACH SIDE
#224 AND #240)
HOLD-IN COIL
(SMALLER
TERMINALS
TOP AND BOTTOM
#226 AND #237)