Toshiba RAV-SM563UT-E Service Manual/Integration page 155

No. Part name
‡
Fan motor 1) Perform the works in 1 of
2) Take off flange nut fixing the fan motor
3) Remove the propeller fan.
4) Remove connector for the fan motor from
5) Take off fixing screws (4 pcs) with sup-
6) When replacing the fan motor at lower
* Cautions in assembling fan motor
• Be sure to mount the propeller fan and the
fan motor at upper and lower sides be-
cause they are different.
• Tighten the flange nut with the following
torque.
• The same propeller fan and the fan motor
are used at upper and lower sides.
• Tighten the flange nut with the following
torque.
• Be sure to mount the motor lead fixed plate
so that the fan motor lead is not caught in.
• Be sure that the propeller fan does not
come to contact with the fan motor lead.
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedure
with the propeller fan.
• Loosen the flange nut by turning clock-
wise. (When tightening, turn it counter-
clockwise.)
the inverter.
porting the fan motor so that it does not
fall down.
side, remove the motor lead fixed plate
which is fixed to the partition plate with
screw (ST1T Ø4 × 10, 1 pc), pull the fan
motor lead out of the partition plate, and
then remove the fan motor.
<In case of RAV-SP1102AT-E>
Upper side: 9.8N·m (100kgf·cm)
Lower side: 4.9N·m (50kgf·cm)
<In case of RAV-SP1402AT-E>
Upper side: 9.8N·m (100kgf·cm)
Lower side: 9.8N·m (100kgf·cm)
– 155 –
www.heronhill.co.uk
 ‚
and 1 of .
Flange nut Flange nut
Propeller fan
Fan motor connector at upper side
Fan motor connector at lower side
Fan motor
lead
Partition
plate
Motor lead
fixed plate
Remarks
Loosen by Loosen by
turning clockwise. turning clockwise kwise.
Cycle P.C. board
Fan motor
Fax: 01823 665807