Toshiba RAV-SM563UT-E Service Manual/Integration page 144

No. Part name
„
Inverter 7) Remove connectors which are connected
assembly from the cycle P .C. board to other parts.
(Continued)
Compressor lead: Remove terminal cover of
the compressor, and remove the lead wire
from terminal of the compressor.
*(Note 1)
Remove the connectors by releasing lock of the
housing.
8) Remove various lead wires.
9) Cut off tie lap which fixes various lead wires
to the inverter assembly.
…
Cycle P .C. 1) Remove connectors and lead wires which
board are connected from the cycle P .C. board to
other parts.
1. Connector
*(Note 1)
Remove the connector while releasing locking of
the housing.
2) Mount a new cycle P .C. board.
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedure
CN600: TD sensor (3P: White)
CN601: TO sensor (2P: White)
CN604: TE sensor (2P: White) *Note 1)
CN605: TS sensor (3P: White) *(Note 1)
CN301: Outdoor fan (3P: White) *(Note 1)
CN300: Position detection (5P: White)
CN500: Case thermo. (2P: Blue) *(Note 1)
CN702: P .M.V. (Pulse Motor Valve)
coil (6P: White) *(Note 1)
Relay connector:
4-way valve (3P: Yellow) *(Note 1)
Relay connector:
Reactor 2 pcs. (2P: White) *(Note 1)
CN01 : Connection with IPDU P .C. board
(5P , Red) *(Note 1)
CN02 : Indoor/Outdoor connection
terminal block (5P, Black)
CN03 : Connection with IPDU P .C. board
(3P , White) *(Note 1)
CN04 : Connection with IPDU P .C. board
(2P , White) *(Note 1)
CN700 : 4-way valve (3P , Yellow) *(Note 1)
CN800 : Connection with IPDU P .C. board
(5P , Red) *(Note 1)
– 144 –
www.heronhill.co.uk
Remarks
Inverter box (Metal sheet)
P.C. board
base
Cycle control
P.C. board
assembly
Inverter
control
P.C. board
assembly
Cycle control
P.C. board
assembly
Fax: 01823 665807