Toshiba RAV-SM563UT-E Service Manual/Integration page 139

No. Part name
‡
Compressor 1) Perform works of items 1 of
‚
2) Discharge refrigerant gas.
3) Remove the partition plate.
(ST1T Ø4 × 10L, 2 pcs.)
4) Remove the noise-insulator.
5) Remove the terminal covers of the
compressor, and disconnect lead
wires of the compressor and the
compressor thermo assembly from
the terminal.
6) Remove pipes connected to the
compressor with a burner.
Pay attention to that flame does not
involve 4-way valve or PMV. (If doing
so, a malfunction may be caused.)
7) Take off the fixing screws of the
bottom plate and heat exchanger.
(ST1T Ø4 × 10L, 2 pcs.)
8) Take off the fixing screws of the valve
clamping plate to the bottom plate.
9) Pull upward he refrigerating cycle.
10) Take off nut fixing the compressor to
the bottom place.
When reconnecting the lead wires to
the compressor terminals after
replacement of the compressor, be
sure to caulk the Faston terminal
without loosening.
ˆ
Reactor 1) Perform works of item 1 of
2) First take off two screws
(ST1T Ø4 × 10L) of the reactor fixed
to the reactor support.
3) Remove the reactor support from the
partition plate.
(ST1T Ø4 × 10L, 4 pcs.)
4) Take off two screws
(ST1T Ø4 × 10L) directly attached to
the partition plate.
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedure
ƒ „ …
, , , .
CAUTION
CAUTION

– 139 –
www.heronhill.co.uk

and
Remove
(Discharge pipe)
Remove
(Suction pipe)
ƒ
and .
Reactor
Remarks
Partition plate
Compressor
lead
Case thermo
Heat exchanger
Screw
Valve
support board
Screws (2 pcs.)
Compressor bolt (3 pcs.)
Partition
Reactor
plate
support board
Fax: 01823 665807