Toshiba RAV-SM563UT-E Service Manual/Integration page 129

No. Part name
†
Drain pump 1. Remove the drain pan and float switch.
2. Remove the set screws (3 positions) of
3. Remove the set screws (3 positions) of
‡
TC, TCJ sensor 1. Remove the set screws (5 positions) and
2. Pull out the sensor is inserted into pipe of
ˆ
Heat 1. Take down the main unit and then treat
exchanger
2. Remove the drain pan.
3. Remove the check port cover (right side).
4. Remove the set screws (6 positions) and
5. Remove the set screws (2 positions) of
6. Remove the set screws (7 positions) of
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedure
fixing drain pump plate and main unit.
fixing drain pump plate and drain pump.
check port cover (right side).
the heat exchanger.
the heat exchanger on the floor.
check port cover (left side).
fixing heat exchanger and main unit
(left side).
fixing heat exchanger and main unit
(front right side).
– 129 –
www.heronhill.co.uk
Remarks
Drain pump
Drain pump holder
Screws (Fixing drain pump holder)
Screws (Fixing plate and drain pump)
Drain pump holder
(6) -3. View from reverse side of drain pump 6
Checking port cover (Right side)
Screws (Fixing check port cover (Right side))
Check port cover (Left side)
Screws (Fixing check port cover (Left side))
Screws (Fixing heat exchanger)
Main unit (Left side)
Main unit (Front side)
Screws
Fax: 01823 665807
6 -2
6 -3
7 -1
8 -4
8 -5
8 -6