Conveyor Disassembly For Cleaning; Finger Removal & Disassembly - Lincoln Series 1100 Installation And Operating Instructions Manual

CONVEYOR DISASSEMBLY FOR CLEANING

DISASSEMBLY: The Connecting Links may be
removed with a pair of pliers by slipping the eye of
the connecting link over the wire of the other links.
Also notice the direction of the opening on the
other links. The belt will have to be reinstalled
with the opening facing the same way.
NOTE: The Conveyor Belt of the Impinger II and the Advantage oven does not have a tension adjustment.
If the belt would become too lose, a link will have to be removed to tighten. A belt that is too tight will also
cause operational problems due to excessive drag. We suggest that you may have a qualified service
technician perform this adjustment.
WARNING: Careful consideration should be exercised prior to removing a belt link because a belt that is
too tight will impede the smooth operation of the conveyor.
FINGER ASSEMBLY REMOVAL
!
CAUTION:
1. Open Door.
16
OVEN MUST BE COOL
NOTE: Door may be removed by lifting from hinges.
Impinger II – Digital Advantage Ops Manual –Dom & Int'l
REASSEMBLY: Put conveyor belt back on by
setting the rolled belt to the idler end of the
conveyor and thread approximately 2/3 of the belt
over the bottom slider bed. Be sure belt is not
upside down. Reconnect conveyor belt by
slipping the connecting links back in place.