Sony Trimaster PVM-L2300 Operation Manual page 66

Menu
ALM Hold Reset
Time Code
Checkerboard
L/R Switch
66
Display Function Menu
Function and operation ([
When the item is selected, the peak hold of the audio level meter is canceled.
Notes
• The ALM Hold Reset is not selected in the following cases:
– When the option slot number in which the BKM-250TG is installed is not selected in Slot
No of the Input Configuration menu
– When Audio Level Meter is set to Off
– When Peak Hold is set to Off or Auto in the Audio Level Meter menu of the On Screen
Set menu of the System Configuration menu
• Use the controller with software version 1.4 or higher to assign this function to the function
button of the controller.
Sets whether or not to display the time code ([Off] or On).
Notes
• When the option slot number in which the BKM-250TG is installed is not selected in Slot No
of the Input Configuration menu, the time code cannot be displayed.
• Use the controller with software version 1.4 or higher to assign this function to the function
button of the controller.
Sets whether or not to display the left and right 3D video signals in a checkerboard pattern
([Off] or On).
Notes
• The Checkerboard display cannot be set in the following cases:
– When the option slot number in which the BKM-250TG (with serial number 7100001 or
higher) is installed is not selected in Slot No of the Input Configuration menu.
– When the dual-link display is used
– When the internal signal is displayed
– When the captured frame is displayed
• Use the controller with software version 1.5 or higher to assign this function to the function
button of the controller.
Sets whether or not to display either the left and right 3D video signals on the screen by
switching them alternately ([Off] or On).
Notes
• The L/R Switch display cannot be set in the following cases:
– When the option slot number in which the BKM-250TG (with serial number 7100001 or
higher) is installed is not selected in Slot No of the Input Configuration menu.
– When the dual-link display is used
– When the internal signal is displayed
– When the captured frame is displayed
• Use the controller with software version 1.5 or higher to assign this function to the function
button of the controller.
]: factory setting)