Changing The Aspect Ratio Of The Screen - Sony Trimaster PVM-L2300 Operation Manual

Connect the cable to the same input number (both INPUT
1 or both INPUT 2) of the input adaptors installed in
OPTION 1 and 2 option slots, or OPTION 3 and 4 option
slots.
OPTION 1 and 2
OPTION 3 and 4
When the BKM-250TG is used, install the Link A signal
to INPUT 1, and the Link B signal to INPUT 2.
For 3D signal analyzing function
Use a 3D-compatible BKM-250TG (with serial number
7100001 or higher) and input the left 3D signal to INPUT 1
and the right signal to INPUT 2.
22

Changing the Aspect Ratio of the Screen

Example of Dual-link
cable connection
INPUT 1
INPUT 2
INPUT 1
INPUT 2
INPUT 1
INPUT 2
Changing the Aspect
Ratio of the Screen
The 16:9 frame is installed at the factory. The aspect ratio
can be switched from 16:9 to 16:10 by removing the 16:9
frame.
To display the native scan picture (×2 mode) of the 576/50i
signal, or whole picture of the UXGA or WUXGA signal,
remove the 16:9 frame.
1
Remove the front frame.
2
Remove 10 screws and then remove the 16:9 frame.