Displaying Two Signals On One Screen; (Picture&Picture) - Sony Trimaster PVM-L2300 Operation Manual

Displaying Two Signals
on One Screen
(Picture&Picture)
Two input signals are output on the monitor. Side by Side
mode is useful for adjusting the color or comparing two
pictures.
You can input the file loaded in the Capture menu (page
62) of the Display Function menu.
Side by Side (side by side)
Signal A Signal B
Notes
• The input signals from INPUT 1 and INPUT 2 of one
input adaptor are not displayed in the multi display.
Two or more input adaptors are required to use the input
signals from the input adaptor as signal A and signal B.
• You cannot select the same channel number as channels
for signal A and signal B. And set a different channel
number of the different input adaptor for signal A and
signal B.
• When signal A and signal B are not the same signal
format and signal system, the pictures may not be
displayed correctly.
• The input of signal A is not changed in the multi display.
• The internal signal is not displayed in the multi display.
• The captured picture data is not used to display as signal
A and signal B at the same time.
• The signals are not displayed in the multi display mode
when Pixel Zoom is set to on.
Procedure
1
Select the channel number and set the input signal to
display as signal A.
2
Select the Side by Side mode with the function button*
of the controller or in the Function Switch menu of the
Display Function menu and set it to On.
For details on the Function Switch menu, see the
"Function Switch" (page 63) of the Display Function
menu.
86
Displaying Two Signals on One Screen (Picture&Picture)
Two pictures are
displayed side by side.
* The function of Picture&Picture is assigned to each function
button of the controller in the Function Key menu (page 79)
of the Controller menu.
3
Select the channel number and set the input signal to
display as signal B.
The channel for signal B is set to CH01 at the factory
setting.
To display the captured picture data file
You can use a captured picture other than the picture
selected by designating the channel number as signal A and
signal B.
Instead of setting the channel number in step1 or step3,
press the Capture Load button* or select Load in the
Capture menu.
For details on the Capture menu, see the "Capture" (page
62) of the Display Function menu.
* Capture Load is assigned to the controller in the Function Key
menu (page 79) of the Controller menu.
To end the multi display
Set Side by Side to Off in Function Switch menu (page 63)
of the Display Function menu, or set the function button of
the controller to off.