Toshiba e-studio556 Troubleshooting Manual page 40

1 TROUBLESHOOTING FOR THE HARDWARE
Remove the jammed staples.
6
Push the knob to lower the shutter.
7
Check that the shutter is securely held by the latch of the green lever.
Fit the staple cartridge.
8
Insert each cartridge until it is fixed with a click.
9 Unlock the stapler by pulling its handle toward you.
Then return the stapler to its original position.
10 Carefully insert the saddle stitch unit into the finisher.
Make sure of the following two requirements before test stapling:
11
 The Saddle Stitch Finisher is securely attached to the equipment.
 A3, B4, A4-R, LD, or LT-R paper is set in the drawer.
38 Clearing a Staple Jam
2
1