Before Calling For Service - Electra Monoblock 7 Service Manual

BEFORE CALLING FOR SERVICE

Before calling for service, please check the following malfunctions and correct as needed.
Should this fail to remedy the malfunction, contact your nearest authorized service center for qualified assistance.
PROBLEM
Unit does not operate.
Operation indicator doesn't
light up.
Unit operates for only brief
periods in cooling or dry
mode.
Unit functions, but does
not perform efficiency.
Water overflow warning
indicator lights up or blinks.
Unit does not dehumidify.
Unit does not heat.
Unit does not operate
Operation indicator lights.
CAUSE
Power failure.
Plug is disconnected.
The water tank is out of the
unit, or not inserted
properly in place.
Improper temperature
setting.
Window is open.
Source of heat in the room
(cooker, etc.) or room is
over crowded with people.
Unit capacity is insufficient
for load or room size.
Improper temperature
setting.
Air filter is clogged.
Loss of refrigerant.
Room tightly closed.
Exhaust hose blocked,
twisted or bent.
Water tank is full of water
Temperature setting is too
low.
Remote control
malfunctions.
English 25
APPENDIX A
SOLUTION
Check main fuse.
Insert plug in power supply
socket.
Insert the water tank in its
place.
Decrease temperature
setting.
Close window.
Remove source of heat.
Consult your dealer.
Adjust temperature setting.
Clean filter.
Call for service center.
slightly open window or
outside door.
Remove obstruction.
Drain the water through the
rear drain tube. See Fig. 3
(4). tube.
Reset temperature setting.
Check remote control
batteries.
Tyr to operate from a
closer distance.
Start from on-unit controls.
Perform reset operation by
pressing buttons (9), (10),
(13), (14) fro 5 seconds.
E M
x x
x x
x x
x x
x
x