On-Unit Indicators And Controls-(Electronic Modes); On-Unit Operation; Remote Control - Electra Monoblock 7 Service Manual

ON-UNIT INDICATORS AND CONTROLS - (ELECTRONIC MODES) (See Figure 15)
A. TIMER INDICATOR
Lights up during TIMER and SLEEP operation.
B. OPERATION INDICATOR
Lights up during operation. Blinks to announce
that the remote control infrared signal has been
received and stored. Blinks continuously when
compressor operates in its high-pressure
protection mode.
Lights up during TIMER and SLEEP operation.
C. FILTER AND WATER OVERFLOW
INDICATOR
Lights up when air filter requires cleaning.
Blinks during water overflow.
D. CLEAR/FILTER BUTTON
Press to turn off the FILTER indicator and to
reset the filter function, after the clean filter has
been reinstalled.
Press to cancel the buzzer announcer, if
elected.
E. MODE - COOL / HEAT / ON / OFF - UNIT
OPERATION BUTTON
Used to switch the unit between positions OFF,
ON, COOLING or HEATING, without using the

remote control.

ON-UNIT OPERATION

If the remote control cannot be operated, the air conditioner can be turned on for cooling or heating, or
completely turned off, by pressing MODE button (E). The MODE button will change the operational status of the
unit between the - COOLING - HEATING - OFF positions every time it is pressed.
NOTE: The heating modes are used on units with cooling and heating.
B
A
C
Figure 15
English 14
APPENDIX A
E
D