Introduction; Important Notes - Electra Monoblock 7 Service Manual

Cooling only indoor & outdoor units
Hide thumbs Also See for Monoblock 7:
Table of Contents

Advertisement

INTRODUCTION

This new split mobile air conditioner consists in an indoor and outdoor unit, interconnected by a flexible hose.
The indoor unit is equipped with four castors for easy mobility.
The air conditioner you have purchased is a factory-chagred and ready for use. No special installation is
required; just follow the simple instructions and enjoy this fully featured, versatile air conditioner.
The electronic models are equipped with an electronic microprocessor control system, giving the user the
choice of local or remote control operation, as well as precise temperature setting and control, timer operation
and a built-in protection system for trouble-free and energy-efficient operation.
Capacity based on test conditions of:
o
o
o
Indoor:27 C/80 F DB - 19 C/67 F WB.
o
o
o
Outdoor:35 C/95 F DB - 24 C/72 F WB.
In accordance with ISO 5151, T1 Conditions.
Actual cooling capacity might vary according to the local environmental conditions.
Optimal operating temperature:
o
o
Cooling: 21 -43 C
o
o
Heating: -5 -21 C R22
o
o
-9 -21 C R407 & R410A
PLEASE READ THESE INSTRUCTIONS BEFORE OPERATING THE
AIR CONDITIONER
IF YOUR AIR CONDITIONER IS FOR COOLING ONLY, PLEASE
DISREGARD THE INSTRUCTIONS RELATED TO HEATING

IMPORTANT NOTES:

WARNING
This air conditioner must be grounded for protection against electrical shock.
Electrical connection and power cord replacement should be done only by authorized electricians
and in accordance with electrical regulations and local codes.
Do not expose the unit to rain.
When using this air conditioner for the first time, please do the following:
1. Read the instruction manual and familiarize yourself with the controls.
2. Plug the electric power cord into a power socket which is protected by a proper fuse.
3. Check that all control functions operate properly, including both the remote control unit and on-unit control.
4. Repeat step 3 when the remote control unit is inside its compartment.
5. Disconnect the electric power cord from the power socket, wait 3 minutes and reconnect the unit.
ALL MODELS ..................................................................................................pages:2-7,22-26
Q.C. MODELS UP TO 3.1KW and 4.1KW.....................................................pages:8-10
ELECTRONIC MODELS UP TO 3.1 KW and 4.1KW ...................................pages:11-19
MECHANICAL MODELS UP TO 3.1KW and 4.1KW....................................pages:20-21
o
o
IN THIS MANUAL
English 2
APPENDIX A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sp 11Sp 16

Table of Contents