Table of Contents
Advertisement
1
Approvals and Codes
Appliance Certification
The legend fireplace models discussed in this Installers Guide have been tested to certification
standards.
Certification
MODEL: DV36
TYPE: Direct Vent Gas Fireplace Heaters
STANDARD: AS4553-2008
Installation Codes
This fireplace shall be installed only by authorised persons and in accordance with the manufacturer's
installation instructions, local gas fitting regulations, municipal building codes, electrical wiring
Gas Installations
regulations, AS 5601-2004 -
and any other statutory regulations.
Before installing the fireplace, consult the local building code agency to ensure that you are in
compliance with all applicable codes, including permits and inspections. The appliance must be
electrically grounded in accordance with the electrical wiring regulations.
2
Getting Started
Taking fireplace out of carton, remove all the packing material such as corner
protector, plastic material. Check to see if anywhere on surface is damaged
by transport.
The long distance transport may damage the paint on surface or main part of
fireplace, the installer is supposed to be responsible to the quick check of the
fireplace, once the above damage found, call the supplier to replace or repair.
Introducing the legend Gas Fireplaces
Legend direct vent gas fireplaces are designed to operate with all combustion air siphoned from
outside of the building and all exhaust gases expelled to the outside. The information contained in
this Installers Guide, unless noted otherwise, applies to all models and gas control systems. Gas
fireplace diagrams, including the dimensions, are shown in this section.
Pre-install Preparation
In carton of gas fireplace, there should be some part packed separately, check the part list on
this manual to find those parts.
This gas fireplace and its components are tested and safe when installed in accordance with this
Installers Guide.
5
Advertisement
Table of Contents
