Programming The Remote - Sony KF-E42A10 Service Manual

To connect Do this
Digital satellite Connect only to the HDMI IN
receiver or digital jack. The digital video and audio
terrestrial receiver signals are input from the digital
D
receiver.
Tip
If the digital receiver has an HDMI
jack, connecting via an HDMI cable
will provide the best results.
Note
When using an HDMI-to-DVI cable
or an adapter, be sure to connect the
DVI output connector first; then
connect to the HDMI jack on the TV.
DVD player with Connect to the component jack
component output 1, 2 and the audio jacks
E
1, 2. For better picture quality,
component connection is
recommended if your DVD player
has a component output.
DVD recorder or Connect to the video output jacks
VCR F
to record the image from the
TV. Connect to the audio output
jacks
from the TV on the DVD recorder
or VCR. To turn off the sound of
the TV speakers, set "Speaker" to
"Off" (page 32).
Video game Connect to the S video jack
equipment or DVD or the video jack
player without the audio jacks
component output avoid picture noise, do not connect
GH
the camcorder to the video jack
1 and the S video jack
at the same time. If you connect
mono equipment, connect to the L
(MONO) jack
Hi-Fi audio Connect to the audio output jacks
equipment I
to listen to the sound from the
TV on the Hi-Fi audio equipment.
To turn off the sound of the TV
speakers, set "Speaker" to "Off"
(page 32).
to record to the sound
1
1, 2 or 3, and
1, 2 or 3. To
1
1, 2 or 3.
Programming the
remote
If you have Sony VCRs/DVDs and Sony DVD Home
Theater Systems/Amplifiers, do the following
procedure to program the remote so that you can
operate them using this remote.
Note
Before you start, look up the three-digit code for your
equipment on page 46. For equipment that has more than one
code, try with the first code number.
1
Press and hold the DVD, VCR, or AMP
function button you want to program on the
remote and press the
simultaneously.
The selected function button (DVD, VCR, or
AMP) will flash.
2
Enter the three-digit code using the number
buttons while the function button is lit.
(approximately 10 seconds)
3
Press /-/-- or
programming.
When the programming is done successfully, the
selected function button will flash twice slowly, and
if not, will flash five times quickly.
1
2
3
1
/ button
to complete the
Continued
45
GB