Canon imageRunner iR2270 Service Manual page 65

Message Error
code
TCP/IP error #755
Check server #801
Cannot find server #802
Check address #804
Cause
- IP address set to 0.0.0.0. In
the following two situations,
the IP address is 0.0.0.0.
1) Address could not be
obtained from DHCP,
BOOTP, RARP.
2) Unit launched in IP fixed
mode(keys 1+7 to enter
FIXIPmode).
- TCP/IP protocol stack
resources insufficient. Even
with internal retry (5
times),transmission failed.
- Error generated due to cause
on server side.
- SMB server side file capacity
not sufficient.
- In WindowsNT/2000 server,
password was incorrect.
- In WindowsNT SMB,
common file name did not
match.
- In SMB, a user exists but no
write privileges.
- SMB transmission made to
write-prohibited file of the
same name.
DNS/SMTP setting error(DNS
error)
- No match for specified
directory name.
- In SMB, a user exists but no
write privileges.
Remedy
- Set the IP address correctly or set DHCP,
RARP, BOOTP environments to operate
properly.
- Turn power OFF/ON.
- Reset server.
- Check server status and settings.
- Check the network traffic.
Reprogramme the user mode settings.
(domain name, E-Mail address, DNS, mail
server)
- Check that the destination directory name
is correct.
- Set directory access privileges in the
server.
Chapter 4
4-23