Canon imageRunner iR2270 Service Manual page 64

Chapter 4
Message Error
code
Address does not #704
appear in address
list.
HD full #702
HD full #703
Address table not #706
available
No response #751
4-22
Cause
- An error occurred when
address information was being
obtained from the address list.
(Address deleted from list after
scanning, etc.)
Operation stopped because HD
full (work area).
Operation stopped because HD
full (image area).
- Address table being
imported/ exported from RUI.
- Address book usage doubled
up with other transmission
component (Fax, etc.).
- Server has not booted up.
- Network disconnected. (If
connection cannot be made
with transmission destination,
connection is sometimes cut
mid-way.)
- Reset caused by internal
error. Processing interrupted.
Remedy
- Check address list settings. Or, turn unit
OFF/ON.
- Wait a while then retry.
- Stop broadcast transmission with other
protocols. This sometimes helps to avoid
this problem.
- Wait a while then retry.
- Stop broadcast transmission with other
protocols. This sometimes helps to avoid
this problem.
- Quit access from RUI.
- Wait a while and then retry
- Check transmission destination and
network settings.
- Transmission jobs whose processing has
stopped for some reason or other are forced
to quit by assigning an internal error code
(#751). As a result, after rebooting, the job
is not run.