System Test And Initialization - Aaeon AMB-2000HT-E Series User Manual

Fan-less Panel PCs

System test and initialization

These routines test and initialize board hardware. If the routines encounter an
error during the tests, you will either hear a few short beeps or see an error
message on the screen. There are two kinds of errors: fatal and non-fatal. The
system can usually continue the boot up sequence with non-fatal errors.
Non-fatal error messages usually appear on the screen along with the following
instructions:
Press <F1> to RESUME
Write down the message and press the F1 key to continue the boot up
sequence.
System configuration verification
These routines check the current system configuration against the values
stored in the CMOS memory. If they do not match, the program outputs an
error message. You will then need to run the BIOS setup program to set the
configuration information in memory.
There are three situations in which you will need to change the CMOS
settings:
1. You are starting your system for the first time
2. You have changed the hardware attached to your system
3. The CMOS memory has lost power and the configuration
information has been erased.
The MBC-5410 CMOS memory has an integral lithium battery backup for data
retention. However, you will need to replace the complete unit when it finally
runs down.
Note: Because of chipset limitation, the AMB-2000HT(T)-E series
do NOT support USB CD-ROM booting function.
AMB-2000HT(T)-E Series User Manual V1.4
A M B - 2 0 0 0 H T ( T ) - E
39