Table of Contents
Advertisement
5.4 THERMAL SAFETY CUT-OUT
For your safety, this appliance has been fitted with thermal cut-out. In the event that the product overheats, the cut-out
switches the heat off automatically.
To bring the heat back into operation, remove the cause of the overheating, then unplug or turn off the electrical supply
to the heater for up to 10 minutes.
When the heater has cooled sufficiently, re-connect and switch on the heater.
6. CLEANING AND MAINTENANCE
Warning:
Always disconnect from the power supply before attempting any maintenance.
6.1 CLEANING
Before commencing cleaning, unplug the heater and allow it to cool.
The surface of the heater should be given an occasional wipe over with a soft damp cloth. Do not use detergents
abrasive cleaning powder or polish on the body of the heater. The glass screen should be cleaned carefully with a
chamois leather. Do not use proprietary glass cleaners.
6.2 LAMP REPLACEMENT
Front
Frame
rotisserie
To gain access to the lamps.
1.
Remove the Front Frame by lifting out then up and carefully leave to one side.
2.
Remove the two screws on the fuel effect.
3.
(a) Tilt the fuel effect up, by holding the front ledge (taking care not to damage the logs as they are fragile), and
(b) then lifting out. – see Fig. 8.
4.
For access to the bulbs, carefully rotate the flexible rotisserie out of position ensuring that the rubber grommet is
not lost – see Fig 9.
5.
Unscrew the defective lamp anti-clockwise. Replace with a 230V, 60W E14 SES lamp, do not over tighten (see
Fig. 9).
6.
To refit the fuel effect, locate the front ledge in position, applying pressure at the back corners of the fuel effect
(taking care not to damage the logs) push down until the rear bracket locates under the glass. Screw in position
with the two screws.
fuel
effect
(b)
(a)
2 screws
Fig. 8
- 5 -
grommet
Fig. 9
Advertisement
Table of Contents
