Page 1
For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7208630100R03...
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. W ARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these...
IMPORTANT INSTRUCTIONS gasoline, paint, or flammable materials in the fireplace. liquids are used or stored. ⑱ Do not strike the glass front. ⑭ Do not modify the fireplace. ⑲ Always use a certified electri- Use it only as described in this cian for build-in hard-wired instal- manual.
Page 6
Consult the dealer or an experienced radio/TV technician for help. Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. www.dimplex.com...
Fireplace Installation rating of the circuit breaker. WARNING: Ensure the power cord is not installed so that it is WARNING: The In-Stud pinched or against a sharp edge fireplace is wall mountable and and ensure that the power cord is can be build-in the wall space 16”...
4” (102 mm) space above the floor (mounting holes 29.5” (750 mm) minimum above the floor). Access to the electrical outlet must be maintained. Ensure the installation meets the national and state/provincial electrical codes. www.dimplex.com...
Page 9
Fireplace Installation Other available combinations Figure 3 are A-G, C-G, A-F, A-E, A-D and D-G. 5. Mark the second mounting screw location; ensure that is level with the first with the help of the provided bubble level and the fireplace itself. Screw the threaded drywall Circulation anchor in the drywall with a...
Page 10
Fireplace Installation Figure 4 1. I nstall supplied brackets as shown on 2. Install frame on to both sides of frame fireplace 3. Secure frame on fireplace with supplied self-tapping screws Figure 5 Figure 6 www.dimplex.com...
(Figure 2) Dimplex North America will not 10. Re-install glass assembly into be responsible for inaccuracies fireplace. in the design or manufacture of 11.
Page 12
(Figure 7) 11. Place all connectors inside the unit and secure the junc- tion box cover to unit. Ensure Figure 8 that the cable clamp grips only the jacket of service cable. NOTE: All wiring must be www.dimplex.com...
Fireplace Installation completed prior to installing the Bathroom Installation unit into the wall. This firebox must be protected 12. Place unit in position in the by a GFI receptacle or circuit for opening, push straight in and bathroom use. If receptacle is attach unit to studs using No.
Resetting The Temperature control. Cutoff Switch When in position the unit is Should the heater overheat, an operated with the ON and OFF automatic cut out will turn the fire- buttons of the remote control. www.dimplex.com...
CAUTION: If you need to continu- Battery Replacement ously reset the heater, disconnect To replace the battery: power and call Dimplex customer 1. Slide battery cover open on service at 1-888-DIMPLEX (1-888- the remote control. 346-7539). 2. Install one 12-volt (A23) bat- Remote Control tery in the battery holder.
Quantity of two 40W Chandelier in reverse order. or candelabra bulbs with E-12 Glass Cleaning (small) socket base, 120 Volt. DO NOT EXCEED 40 WATTS The front glass is cleaned in the PER BULB factory during the assembly op- www.dimplex.com...
Page 17
Maintenance eration. During shipment, instal- Figure 11 lation, handling, etc., the front Glass glass may collect dust particles, Assembly these can be removed by dusting lightly with a clean dry cloth. Handles To remove fingerprints or other marks, the glass can be cleaned with a damp cloth.
Limited warranty service requires a proof products is with the purchaser, and in the of purchase of the product. event of a defect the purchaser assumes What Dimplex will do in the event of a the entire cost of all necessary servicing defect? or repair.
Page 19
Warranty uct or part without charge. If Dimplex OR ITS DIRECTORS, OFFICERS, OR is unable to repair or replace such AGENTS HAVE BEEN ADVISED OF product or part, or if repair or replace- THE POSSIBILITY OF SUCH LOSSES, ment is not commercially practicable or...
Need help?
Do you have a question about the V1525BT and is the answer not in the manual?
Questions and answers