Table of Contents
Advertisement
4.4 RECESSED INSTALLATION
In order to ensure it's future safety in use,
it is essential that this fire is securely fixed
to the wall.
IT IS IMPORTANT THAT THE FIXING
DEVICE CHOSEN IS APPROPRIATE
TO THE WALL MATERIAL TO WHICH
THE FIRE IS BEING FIXED. SOME
MODERN INTERNAL
MATERIALS ARE VERY LOW DENSITY
BLOCK AND REQUIRE SPECIALIZED
FIXING DEVICES TO PROVIDE A
SAFE,SECURE INSTALLATION.
The installation of this fire should be
carried out by a competent person.
Follow steps as outlined below :
1
Make sure that the fire is located on a flat surface.
2
In existing fireplaces seal all draughts and vents to prevent chimney debris from falling onto the fireplace insert.
Do not install into an existing fireplace that is prone to dampness.
3
Remove the fire front panel - see 'Lamp Replacement' and Fig. 8.
4
Locate the 4 fixing holes, position the fire accordingly, and firmly fix the appliance to the wall using the appropriate
screws - see Fig. 3 for hole fixing dimensions and recommended recess size.
5
Replace the front panel.
If you intend to build a purpose built structure/hearth please use the recommended dimensions as indicated in Fig.
If in doubt of any of the above please consult your local builder.
5. OPERATION
5.0 OPERATION
The controls are located at the bottom right hand
corner of
the appliance - see Fig. 1.
Connect the fire to your electricity supply.
Note: When either the remote control or the
manual controls are used the neon's will come
on for 3 seconds indicating the appropriate setting
-
see Fig. 3.
5.1 INITIALIZING THE REMOTE CONTROL
Note: The remote control is packed separately in the carton.
1.
Slide open the battery cover on the back of the remote transmitter.
2.
Install the AAA batteries into the remote control (see Fig. 5).
3.
Replace battery cover.
DISCARD LEAKY BATTERIES
Dispose of batteries in the proper manner according to Provincial and local regulations. Any battery may leak electrolyte
if mixed with a different battery type, if inserted incorrectly, if all the batteries are not replaced at the same time, if
disposed of in a fire or if an attempt is made to charge a battery not intended to be recharged.
BUILDING
Fig. 3
- 3 -
wall plugs
screws
648
550
632
567
668
75
165 Min.
Neon's for indicating
operation level
Fig. 4
Batteries
Fig. 5
3
Advertisement
Table of Contents
