In-Wall Recessed Installation - 100Mm Deep - Dimplex BLF3451-INT Owner's Manual

Fireplace Installation
I n - w a l l
Installation - 100mm Deep
CAUTION: Two people may
be required for various steps of
this procedure.
1. Prepare a wall with a framed
opening of 77.5 cm wide x 42
cm high (Figure 4).
!
NOTE: The sizing has allowed
for 6.4mm around the fireplace
insert for ease of installation. This
fireplace does not require any
additional venting.
2. Choose
supplying power to the unit:
• Plug in (you may run the
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
• Hard wire the fireplace.
!
NOTE: Hard wiring can be done
by removing the plug from the
factory fitted cord and completing
the wiring according to National and
Local Elecrical Codes.
WARNING: Do not attempt to
wire your own new outlets or circuits.
To reduce the risk of fire, electric
shock or injury to persons, always
use a licensed electrician.
R e c e s s e d
your method
Figure 4
of
Figure 5
Mounting
holes
11