No Video; Losing The System's Setup Confi Guration; Memory Errors - Supermicro SuperO X8DTL-3 User Manual

X8DTL-3/X8DTL-i/X8DTL-3F/X8DTL-iF User's Manual

No Video

1. If the power is on but you have no video, remove all the add-on cards and
cables.
2. Use the speaker to determine if any beep codes exist. Refer to the Appendix
for details on beep codes.
Losing the System's Setup Confi guration
1. Make sure that you are using a high quality power supply. A poor quality
power supply may cause the system to lose the CMOS setup information.
Refer to Section 1-6 for details on recommended power supplies.
2. The battery on your motherboard may be old. Check to verify that it still sup-
plies ~3VDC. If it does not, replace it with a new one.
3. If the above steps do not fi x the Setup Confi guration problem, contact your
vendor for repairs.

Memory Errors

When a No_Memory_Beep_Code is issued by the system, check the following:
1. Make sure that the DIMM modules are properly and fully installed.
2. Check if different speeds of DIMMs have been installed. It is strongly recom-
mended to use the same RAM speed for all DIMMs in the system.
3. Make sure you are using the correct type of DDR3 Registered 1333/1066/800
MHz SDRAM (recommended by the manufacturer.)
4. Check for bad DIMM modules or slots by swapping a single module between
all memory slots and check the results.
5. Make sure that all memory modules are fully seated in their slots. Make sure
to follow the instructions given on DIMM population in Section 2-4 in Chapter
2.
6. Check the position of the 115V/230V switch on the power supply.
7. Please follow the instructions given in the DIMM Population Tables listed on
Page 2-8 to install your memory modules.
3-2