Registering A Bluetooth; About The Bluetooth Module; Registering A Bluetooth Device - Kenwood DPX513WBT Instruction Manual

14. Registering a Bluetooth

14-1. About the Bluetooth module

This unit conforms to the following Bluetooth
specifications:
Version
Bluetooth Ver.2.1+EDR Certified
Profile
HFP (Hands Free Profile)
SPP (Serial Port Profile)
PBAP (Phonebook Access Profile)
OPP (Object Push Profile)
A2DP (Advanced Audio Distribution Profile)
AVRCP (Audio/Video Remote Control Profile)
For the cell-phones verified for compatibility, access
the following URL:
http://www.kenwood.com/cs/ce/bt/
Notes
• The units supporting the Bluetooth function have been
certified for conformity with the Bluetooth Standard
following the procedure prescribed by Bluetooth
SIG. However, it may be impossible for such units to
communicate with your cell-phone depending on its type.
• HFP is a profile used to make a hands-free call.
• OPP is a profile used to transfer data such as a phone book
between units.
34
|
DPX513WBT

14-2. Registering a Bluetooth device

You can register your Bluetooth device in this unit.
1
Start registering a unit by operating the
Bluetooth device.
By operating the Bluetooth device, register
the hands-free unit or audio unit (pairing).
Select "DPX5**WBT" from the list of found units.
2
If "PAIRING PASS ****** (Bluetooth device
name) PRESS VOLUME KNOB" appears,
proceed to step 4.
3
Input the PIN code ("0000") in the Bluetooth
device.
Check that registration is complete on the
Bluetooth device. PIN code is set to "0000" as the
default. You can change this code.
See <17-1. Registering the PIN code> (page 40)
"PAIRING PASS ****** (Bluetooth device name)
PRESS VOLUME KNOB" appears.
4
Press the [Control knob].
Pairing starts. When is it completed, "PAIRING OK"
appears.
Bluetooth module that can be used with this unit
• For details on the Bluetooth cell-phone with the hands-free
function, see <14-1. About the Bluetooth module> (page
34).
About automatic connection of the iPod touch or iPhone
through Bluetooth
• This unit is compatible with an Apple Auto Pairing function.
Connecting the iPod touch or iPhone to this unit with USB
cable will automatically register it as a Bluetooth device. See
<"AUTO PAIRING"> (page 41).
1. The Bluetooth function of the iPod touch or iPhone is
turned on first.
2. Connect an iPod touch or iPhone to the USB terminal.
3. Press the volume knob to pair once you have confirm the
passcode.
When registration is impossible
• If there are 5 Bluetooth devices registered, you cannot
register a new Bluetooth device.
• When any error code appears while the pairing is in
progress, refer to <20-3. Error messages> (page 51).
When SMS is received
• When the connected Bluetooth device receives SMS, "SMS
RECEIVE" is displayed on this unit.