Replacing The Door Seal - Siemens HB870570 Instruciton Manual

Replacing the glass cover
Replacing the door
seal
82
3.
Remove the glass cover of the right hand
oven light. To do this, use a spoon handle to
press down the metal tab - Fig. A. Now remove
the glass cover.
4.
Replacing the oven light.
Use the thumb and index finger of your left hand
to pull out the light from behind the bar. Do not
turn - Fig. B. Insert the replacement light, taking
care to position the pins correctly. Press in the
new light tightly.
5.
Reinstall the glass cover of the right hand
oven light. The labelling on the glass must be
at the back. To do this, insert the glass cover at
the top. Use the spoon handle to press down the
bottom tab. The glass cover will now click into
place - Fig. C.
6.
Remove the tea towel.
7.
Switch on the fuse again and reset the time.
If the glass cover of the oven light is damaged, it
must be replaced. Replacement glass covers can be
obtained from the after sales service. Please specify
the E number and FD number of your appliance.
The door seal must be replaced if it becomes
defective in any way. The replacement part can be
obtained from your local customer service centre.
Always make sure that you give the E number and the
FD number when ordering.
1.
Open the oven door.
2.
Remove the old door seal.
3.
6 hooks are attached to the door seal. Attach the
new door seal to these hooks on the inside of the
oven door and press into position.
Note: The impact point of the door seal must be in the
middle at the bottom of the door.