HP ProCurve 2510G Series Installation And Getting Started Manual page 55

Tip Problem
➐
The port may be Use the switch console to see if the port is part of a dynamic trunk (through the LACP
improperly feature) or to see if Spanning Tree is enabled on the switch, and to see if the port may have
configured, or been put into a "blocking" state by those features. The show lacp command displays the
the port may be in port status for the LACP feature; the show spanning-tree command displays the port status
a "blocking" for Spanning Tree.
state by the
Also check the Port Status screen using the show interfaces command to see if the port
normal operation
has been configured as "disabled".
of the Spanning
Other switch features that may affect the port operation include VLANs and IGMP. Use the
Tree, LACP, or
switch console to see how the port is configured for these features.
IGMP features.
For software troubleshooting tips, see the chapter "Troubleshooting" in the Management
and Configuration Guide, which is available on the ProCurve Web site www.procurve.com.
Make sure also, that the device at the other end of the connection is indicating a good link
to the switch. If it is not, the problem may be with the cabling between the devices or the
connectors on the cable.
Diagnosing with the LEDs
Solution
Troubleshooting
4-7