Using The Console Setup Screen - HP ProCurve 2510G Series Installation And Getting Started Manual

Configuring the Switch
N o t e
By default, the switch is configured to acquire an IP address configuration
from a DHCP or Bootp server. To use DHCP/Bootp instead of the manual
method described in this chapter, see "DHCP/Bootp Operation" in the
Management and Configuration Guide, which is available on the ProCurve
Web site www.procurve.com.

Using the Console Setup Screen

The quickest and easiest way to minimally configure the switch for manage-
ment and password protection in your network is to use a direct console
connection to the switch, start a console session, and access the Switch Setup
screen.
1.
2.
3.
3-2
Using the method described in the preceding section, connect a terminal
device to the switch and display the switch console command (CLI)
prompt (the default display).
The CLI prompt appears displaying the switch model number,
for example:
ProCurve Switch 2510G-24#
At the prompt, enter the setup command to display the Switch Setup
screen. The following illustration shows the Setup screen with the default
settings.
2510G-24
Use the key to select the Manager Password field and enter a manager
[Tab]
password of up to 16 characters.
2510G-24