Restoring The Factory Default Configuration - HP ProCurve 2510G Series Installation And Getting Started Manual

Restoring the Factory Default
Configuration
As part of your troubleshooting process on the Switch, it may become
necessary to return the switch configuration to the factory default settings.
This process momentarily interrupts the switch operation, clears any
passwords, clears the console event log, resets the network counters to zero,
performs a complete self test, and reboots the switch into its factory default
configuration including deleting the IP address, if one is configured.
N o t e
This process removes all switch configuration changes you have made from
the factory default settings. This includes, for example, configuration of
VLANs, Spanning Tree, trunks, and stacking. Returning the configuration of
these features to their factory default settings (usually disabling them) may
result in network connectivity issues.
If the switch has a valid configuration, and you are restoring the factory default
settings for a reason other than configuration problems, you should save the
switch configuration prior to performing the factory default reset. Then, after
the reset and resolution of the original problem, you can restore the saved
configuration to the switch. For both the save and restore processes, you can
use the console copy command. For more information on this command, see
the Management and Configuration Guide, which is available on the
ProCurve Web site www.procurve.com.
You can restore the factory default configuration either on the switch itself,
or through the switch console.
To execute the factory default reset on the switch, perform these steps:
1.
2.
3.
To restore the factory default configuration using the console, execute the
erase startup-config command from the console command prompt.
Using pointed objects, simultaneously press both the Reset and Clear
buttons on the front of the switch.
Continue to press the Clear button while releasing the Reset button.
When the Test LED begins to blink, release the Clear button.
The switch will then complete its self test and begin operating with its
configuration restored to the factory default settings.
Troubleshooting

Restoring the Factory Default Configuration

4-11