ADDER AdderLink Infinity 1002 User Manual page 34

RX System Configuration (2 of 2)
Note: ALIF dual screenshot shown above. ALIF 1002 models will provide options for
a single video port only.
Target Transmitter Unit Settings
This section is where you configure the IP address details of the ALIF transmitter(s) that this receiver will
connect with. You can quickly set all peripheral feeds (video 1/2, audio, USB and serial) to use the same primary
(and secondary) locations using the IP Address (System port) and IP Address 2 (Teaming port) entries.
For normal one-to-one connections enter the IP address(es) that match the System IP Address and Teaming
Port IP Address settings of the target transmitter unit in this section. However, if this receiver is to take part
in a multicast connection then you need to enter the IP address(es) that are set within the transmitter's Target
Multicast Configuration section.
Alternatively, click the arrow to expand the section as shown bottom left.
In the expanded view, for each peripheral feed, the first IP address is that of the targeted TX unit's System port
(to match the address(es). IP Address 2 corresponds to the optional Teaming port (when used).
The use of the Teaming port as a parallel secondary link offers a degree of redundancy for your ALIF installation.
With the Teaming ports of the TX and RX units connected in addition to the System ports, if one of the links
should fail for any reason, there will be a short delay for a few video frames (and possibly some on-screen
corruption) as all the data packets are rearranged to be sent down the other link. Obviously the bandwidth will
be halved and frame rate will automatically drop, but a fully usable system will remain.
[ALIF dual only] The Video No. for DVI-D-x option allows you to determine which video feed is sent to each
output port. By default, the primary video feed is presented at port 1 while the secondary feed goes to port 2.
These options allow you to 'clone' one of the video signals and deliver it to both ports - thus, requiring only
one receiver to drive two displays. This solution is commonly used where two signage displays are mounted
back-to-back and need to show the same video feed. With these options, you can also swap the two video
feeds between the two ports.
To get here
1 Connect your computer to a port on the front panel.
2 Run a web browser and enter the IP address of the Management (ALIF dual only) or System port used:
http://192.168.1.42 (management port) or http://169.254.1.32 (system port)
If the address is unknown, perform a manual factory
3 If necessary, click the System Configuration link.
4 Click within the Target Transmitter Unit Settings section.
reset.
33