Pre-Assembly - Horizon Fitness PARAGON 4 Owner's Manual

WATER BOTTLE HOLDER
Paragon 6
shown
GRIP PULSE HANDRAILS
CONSOLE MAST
MOTOR COVER
TRANSPORT WHEEL
RUNNING BELT / RUNNING DECK
SIDE RAIL
4
CONSOLE
FAN
IN-REACH CONTROLS
SAFETY KEY PLACEMENT
ON/OFF SWITCH
CIRCUIT BREAKER
POWER CORD
ROLLER END CAP
REAR ROLLER TENSION/ADJUSTMENT BOLTS
PRE ASSEMBLY
TooLS INCLUDED:
F 5 mm L-Wrench/Screwdriver
F 8 mm T-Wrench
UNPACKING
F Screwdriver (not included)
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this
unit. Never open box when it is on its side. Once the banding straps have been removed,
PARTS INCLUDED:
do not lift or transport this unit unless it is fully assembled. Unpack and assemble the unit
F 1 Console Assembly where it will be used. Never grab hold of any portion of the incline frame and attempt to
lift or move the treadmill.
F 2 Console Masts
F 1 Hardware Kit
F 1 Safety Key
WARNING
F 1 Power Cord
F 2 Handlebar Cover Set
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
F 2 Water Bottle Holder
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NEED HELP?
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
If you have questions or if partially threaded in before completely tightening any ONE bolt.
there are any missing parts,
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
contact your local dealer.
such as lithium bike grease is recommended.
ALL
MODELS
5