Assembly Step - Horizon Fitness PARAGON 4 Owner's Manual

ASSEMBLY STEP 1

HARDWARE foR STEP 1 :
Paragon 6
Shown
BOLT (A)
M8 x 10
Qty: 2
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
BOLT(A)
MAIN FRAME BRACKET
6
A Cut the yellow banding straps and lift the running
deck upward to remove all contents from underneath
the running deck.
B Open HARDWARE BAG 1
C Screw in the 2 Bolt(A) to the mAin fRAmE
BRAckEt.
D Connect the conSolE cABlES at RiGHt
conSolE mASt an carefully tuck wires to
conSolE mASt to avoid damage.
E Align and attach right conSolE mASt with mAin
fRAmE BRAckEt using Bolt(A) and repeat on the
other side.
NOTE: Do not pinch console cable when placing
the mast onto the main frame bracket. You may
need extra help assembling step 1 o 2
ASSEMBLY STEP 2
HARDWARE foR STEP 2 :
BOLT (B) SPRING WASHER (C) FLAT WASHER (D)
M8 x 70 mm Φ 8.2 mm Φ 8.2 mm
Qty: 8 Qty: 8 Qty: 8
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
FLAT WASHERS (D)
SPRING WASHERS (C)
BOLTS (B)
A Open HARDWARE BAG 2
B Attach conSolE mASt to mAin fRAmE
BRAckEt using 4 BoltS (B), 4 SpRinG
WASHERS (c) and 4 flAt WASHERS (D).
C Repeat step B on other side.
NOTE: Do not tighten bolts until step 4 is complete.
Paragon 6
Shown
7