Toyota Land Cruiser 2001 Owner's Manual page 163

WWW.MANUALS.WS
R
(b) Operating the HomeLink
R
To operate the HomeLink , press the ap-
R
propriate HomeLink button to activate the
programmed device. The HomeLink
cator light should come on. The Home-
R
Link continues to send the signal for up
to 20 seconds as long as the button is
pressed.
(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
WWW.MANUALS.WS
CAUTION
_
When programming the HomeLink-
R
indi-
R
Universal Transceiver, you may
be operating a garage door or
other device. Make sure people
and objects are out of the way of
R
the garage door or other device
to prevent potential harm or da-
mage.
_
Do not use this HomeLink
versal Transceiver with any garage
door opener that lacks the safety
stop and reverse feature as re-
R
quired by federal safety standards.
(This includes any garage door
opener model manufactured before
April 1, 1982.) A
opener, which cannot detect an
object, signaling the door to stop
and reverse, does not meet cur-
rent federal safety standards. Us-
ing a garage door opener without
these features increases risk of
serious injury or death.
'01 L/C U (L/O 0008)
FCC ID: CB2V94800
CANADA: 1763 102 264
This device complies with FCC Rules
part 15. Operation is subject to the fol-
lowing two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence that may be received, including
interference that may cause undesired
operation.
WARNING: This transmitter has been
R
tested and complies with FCC and
Uni-
DOC/MDC rules.
cations not expressly approved by the
party responsible
could void the user's authority to op-
erate the device.
garage door
Changes or modifi-
for compliance
163