Checking The Engine Oil Level - Toyota Land Cruiser 2001 Owner's Manual

WWW.MANUALS.WS

Checking the engine oil level

Low level
Full level
Add oil O.K. Too full
With the engine at operating tempera-
ture and turned off, check the oil level
on the dipstick.
1. To get a true reading, the vehicle
should be on a level spot. After turning
off the engine, wait a few minutes for
the oil to drain back into the bottom of
the engine.
2. Pull out the dipstick, and wipe it clean
with a rag.
WWW.MANUALS.WS
3. Standing up on the left side of the
vehicle, reinsert the dipstick in the di-
rection so that the "ENGINE OIL" on
top should be read correctly and push
it in as far as it will go, or the reading
will not be correct.
'01 L/C U (L/O 0008)
4. Pull the dipstick out and look at the oil
level on the end.
CAUTION
Be careful not to touch the hot ex-
haust manifold.
If the oil level is below or only slightly
above the low level, add engine oil of
the same type as already in the engine.
Remove the oil filler cap and add engine
oil in small quantities at a time, checking
the dipstick.
The approximate quantity of oil needed to
fill between the low level and the full level
on the dipstick is indicated below for ref-
erence.
When the level reaches within the correct
range, install the filler cap hand–tight.
Oil quantity, L (qt., Imp. qt.):
1.5 (1.6, 1.3)
249