Table of Contents
Advertisement
Reverse this procedure to install the USB board.
NOTE:
When reinstalling note that the screw goes into the upper hole.
Power connector cable
Description
Power connector cable (includes cable and connector)
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (select models only) (see
c.
Keyboard (see
d.
Top cover (see
e.
USB board (see
Remove the power connector cable:
1.
Turn the computer upright with the right side toward you.
2.
Disconnect the power connector cable (1) from the system board.
3.
Remove the two Phillips M2.5×5.0 screws (2) that secure the power connector cable to the base
enclosure.
4.
Lift the bracket from the connector (3).
64
Chapter 4 Removal and replacement procedures
Downloaded from LpManual.com Manuals
Battery on page
36).
Hard drive on page
43)
Optical drive on page
Keyboard on page
47)
Top cover on page
49)
USB board on page
63)
Spare part number
608273-001
45)
Advertisement
Table of Contents
