When You Use A Panasonic Proprietary Telephone - Panasonic KX-TD1232 User Manual

When You Use a Panasonic Proprietary Telephone

If you use a Panasonic proprietary telephone and the Console, they may have some of the useful
function buttons listed below. These buttons make operations simple. The illustrations may differ from
the buttons on your telephone.
ANSWER: Used to answer an incoming
ANSWER
call.
AUTO ANSWER / MUTE: Used to receive
AUTO ANSWER
an incoming intercom call in the hands-
free mode or mute the microphone during
MUTE
a conversation.
AUTO DIAL / STORE: Used for System
AUTO DIAL
Speed Dialling or storing program
changes.
STORE
CO: Used to make or receive an outside
call. A Loop-CO button supports all lines.
(CO)
Pressing this button seizes an idle line
automatically. (Button assignment is
required.)
Also used as the desired function
buttons. (Button assignment is required.)
(Only the CO "number" (e.g. 1, 2) may be
shown on some telephones.)
Conference: Used to establish a three-
party conversation.
CONF
DSS: Used to access the extension.
(Only the "S" may be shown on some
telephones.)
(DSS)
FLASH / RCL: Used to send a f ash
FLASH / RCL
signal to the Central Office or another
connected PBX. Or used to disconnect
the current call and make another call
without hanging up.
Function: Located beside the display.
Used to perform the displayed function or
operation.
Call Forwarding / Do Not Disturb:
Used to perform Call Forwarding or Do
FWD/DND
Not Disturb.
Jog Dial: Used to adjust the volume and
the display contrast or select desired items
for each function.
HOLD: Used to place a call on hold.
HOLD
INTERCOM: Used to make or receive an
intercom call.
INTERCOM
MESSAGE: Used to leave a message
waiting indication or call back the party
MESSAGE
who left the message waiting indication.
MODE: Used to shift the display to access
various features.
MODE
MONITOR: Used for hands-free dialling.
MONITOR You can monitor the party's voice hands-
free.
PAUSE: Used to insert a pause during
dialling. Used to enter the programming
PAUSE
mode instead of using the PROGRAM
button.
PROGRAM: Used to enter and exit the
Programming mode.
PROGRAM
Programmable Function: Located on the
upper part of the CO button or on the DSS
(PF)
Console. Assigns the desired button and
used to access the stored function. Mostly
used as a one-touch dialling button.
(Only the "F and number" may be shown on
some telephones.)
REDIAL: Used to redial.
REDIAL
RELEASE: Used to disconnect the line.
RELEASE
SAVE: Used to store a dialled phone
number and redial.
(SAVE)
Operation 2-5